Madcow Posted March 5, 2018 Share Posted March 5, 2018 Hey Everybody, This is my first post... and first armor build. I'm really nervous (about the build, not the post) Anyway, my armor is en route from the UK. So, while I patiently wait, I bought a cheap Rubies blaster to fart around with. I saw a handful of builds online, so I am following along with a few other people's builds. My question is, I have seen them taken apart; so I tried to do so with mine. I took out the screws but it looks like some sort of adhesive is also involved. Any suggestions for removing the adhesive without damaging the plastic? Hopefully, if my armor arrives, I will try to make the build party on the 24th. Thanks, Tom Quote Link to comment Share on other sites More sharing options...
Stutz Posted March 5, 2018 Share Posted March 5, 2018 For some types of glues, you can use heat, but I doubt that will work on this. Most mods I have seen online, they do not disassemble the blaster first. Pretty much everything can be done externally. Here is a good tutorial: 1 Quote Link to comment Share on other sites More sharing options...
Madcow Posted March 5, 2018 Author Share Posted March 5, 2018 Thanks Stutz. This was one of the builds I was using. I also saw one with an internal barrel and spring. I was also going to tinker with the scope. Quote Link to comment Share on other sites More sharing options...
Gomcse Posted August 30, 2019 Share Posted August 30, 2019 Wow, great tutorial! Quote Link to comment Share on other sites More sharing options...
Jef Posted September 3, 2019 Share Posted September 3, 2019 I pulled one it half but had to cut some bits with a dremmel. Since there were loads of screw holes that needed to be filled with bondo, I didn't worry about cutting it up too much. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.