Balue

Getting a few steps closer! Sent from my SM-G935V using Tapatalk

Working on some straping and adjusting Sent from my SM-G935V using Tapatalk

Did some more work on the bucket tonight Sent from my SM-G935V using Tapatalk

Well made some progress on the bucket at them party over the weekend and finished up some more tonight. Trimmed ears more and mounted them. Just need to do some fine sanding and done. Trimmed and installed S trim Ok..... and couldn't resist! Sent from my SM-G935V using Tapatalk

Thanks, I am going to try and make it. No scratch that I WILL make it up there! Tomorrow Mitch is going to help me trim and fit the thighs and shins. Sent from my SM-G935V using Tapatalk

Starting to see some light! Sent from my SM-G935V using Tapatalk

Great tip, thanks! Sent from my SM-G935V using Tapatalk

Puttin in some more work on the bucket and started gluing the arms and shins together. Sent from my SM-G935V using Tapatalk

Started some gluing. Need more clamps! Will be using magnets when I get to closing seams and adding outer cover strips Sent from my SM-G935V using Tapatalk

Working on the armor while watching ANH for the 40th! Sent from my SM-G935V using Tapatalk

Yeah been doin a ton of reading maybe too much! But still second guessing my self as it's my first armor build and don't want to mess up too bad Sent from my SM-G935V using Tapatalk

Great Thanks! My plan for example on the front shins that require 20mm strips is to cut each side down to 11mm for a 22mm ridge. Then strip it and fit with angled as needed cuts on back side to form and fit. I believe the is an armor party this month hopefully I can make it and get some hands on advise. Sent from my SM-G935V using Tapatalk

Hey all! Aaaand so it begins, i have done most of the rough cutting and am getting to the point where I will need to be doing fitting and fine trimming. I have a question, well a lot actually but one for now to get started. When fitting the legs and arms do I build the front/outside edges to the cover strip specs then size cut mainly on the back/insides? For example the front of the shin ridge do I trim that so it's 20mm wide the strip it? Or make it a tad bigger like 21-22? Just trying to see how it should begin I am not a big guy so don't need to worry about having to shim anything. Today I plan on making coverstrips then start the fitting process. All pieces in the pic have now been rough trimmed so the excess is gone Sent from my SM-G935V using Tapatalk

So it begins! Sent from my SM-G935V using Tapatalk